sheet width 3100 mm
plate thickness 6.0 mm
thickness at "Niro-steel" 4.0 mm
distance between columns 3120 mm
down holder 16 St?ck
oil volume 200 ltr.
cutting angle 1? 30
no. of strokes 15 Hub / min
control ENC 100
table width 500 mm
throat 50.0 mm
Number of working hours 912 h
total power requirement 15.0 KW
weight 7650 kg
range L-W-H 3810 x 2200 x 2050 mm
** from a maintenance workshop (!!)
** very good / well-maintained condition (as new)
** with only 912 operating hours
** current new price ~ 45.000 euros
** Special price on request
--------------------------------------------------
NC electro-hydraulic swing cutting shear
* with DURMA ENC 100M control
* manual cutting gap adjustment
* Incl. pneumatic sheet metal holding device for thin sheet metal cuts
--------------------------------------------------
Furnishing:
- robust electro-hydraulic swing cutting shears
- including DURMA "ENC 100M" NC control unit
* Backgauge preselection - X axis
* Number of pieces
* Cutting length limitation
* swiveling operation, left front
- electro-motorized back gauge, travel = 1,000 mm (X axis)
* on ball screws
* Travel speed 200 mm / sec.
- manual cutting gap adjustment, via eccentric adjustment
- hydraulic hold-down devices
- 1x front side stop .. 1.500 mm
- 2x front support arms .. 1.500 mm
- Ball rollers in the front support table
- hinged finger protection, with safety switch
- Light barrier behind the machine (safety device)
- 1x freely movable foot switch
- original instruction manual
* Special accessories included:
- pneumatic sheet metal holding device for thin sheet metal blanks
* Machine link:
http: / / mhp.logotech.de / hpm / v7 / Datenblatt / datenblatt.php?machineno=1008-9325330
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
état
d'occasion
année de construction
2008
Machine sous tension
non
Envoyer une demande
Offre de:
A + B Werkzeuge Maschinen Handels GmbH Rottweg 17 48683 Ahaus